Hw 130 Motor Control Shield For Arduino Datasheet Better [100% Plus]

// HW-130 Motor Shield Test // Pins defined as per HW-130 mapping

Use the screw terminals:

Standard L298N modules have physical jumpers for ENA and ENB. On the HW-130 Shield, these are often connected to specific Arduino pins. hw 130 motor control shield for arduino datasheet better

Up to with 8-bit speed selection. Up to 2 stepper motors (unipolar or bipolar). // HW-130 Motor Shield Test // Pins defined

| Feature | Specification | | :--- | :--- | | | L298N (ST) | | Operating Voltage | Logic: 5V | Motor Power: 7V – 12V (Recommended), Max 24V | | Output Current | 2A per channel (Max), 1A continuous recommended | | Peak Power | 25W | | Driven Motors | 2x DC Motors OR 1x Stepper Motor (4-wire) | | Protection | Built-in 4x 1N5819 High-speed Schottky Diodes (Back EMF) | | Size | Standard Arduino Shield Dimensions | Up to 2 stepper motors (unipolar or bipolar)

Check the EXT_PWR terminal polarity. Ensure the PWR jumper is configured correctly.

To help you visualize the differences, here is a direct comparison of the HW-130 against the shields mentioned above.