Petrel Tutorial Hot! Jun 2026

Use the process to map properties from your fine static grid directly onto this new coarser simulation grid. Defining Simulation Cases Switch to the Simulation ribbon interface.

Click along a seismic discontinuity on your screen to digitize a fault segment.

Run to average the high-resolution well log facies into the larger 3D grid cells intersecting the well paths. Open the Facies Modeling process. petrel tutorial

and units (Metric vs. Simulation units like Eclipse) is the first critical step. The Ribbon Interface:

Select a line of wells spanning across the reservoir layout. Use the process to map properties from your

Use Sequential Gaussian Simulation (SGS) to populate continuous properties like porosity and permeability. Ensure you constrain the petrophysical properties to your facies model (e.g., populate porosity only within the sandstone facies). 6. Volumetric Calculations

Geological models are often too large (millions of cells) for reservoir simulators to process efficiently. You must upscale the model before running dynamic simulations. Grid Upscaling Run to average the high-resolution well log facies

Petrel applies the standard formula to every grid cell and sums the totals:

Use the toolbar to assign Well Tops to distinct log signatures, ensuring consistency across all wells in the basin. 5. Structural Modeling and 3D Pillar Gridding