When facing an unyielding SUP0108 error, standard patience does not always work. Use the following sequential troubleshooting methods to safely clear the block. 1. Flush the iDRAC / Lifecycle Controller Job Queue
The SUP0108 warning is categorized under Firmware Update Jobs ( SUP ). While it serves as a safety mechanism, it often triggers deceptively when no active update is visible. The top scenarios causing this conflict include:
: Always ask for matching reports and hours of use if buying used. A worn-out SUP0108 loses its “Top” magic quickly. sup0108 top
If a specific task is corrupted in the Lifecycle Controller, you can purge the active queue using RACADM string commands. Log into your system via SSH.
The operating system will push the payload straight to the target component's EEPROM, sidestepping the stuck deployment queue of the management card. Summary Technical Profile Technical Specification Subsystem Class Updates (SUP = Firmware Update Job) Severity Rating Primary System Impact Temporary lockout of firmware flashing tools Recommended Action When facing an unyielding SUP0108 error, standard patience
When the system is in this state, any secondary attempts to flash firmware, update drivers, or execute configuration jobs are automatically blocked to prevent data corruption or system instability. The standard system message appears as:
Disconnect the power cables from the Power Supply Units (PSUs). Flush the iDRAC / Lifecycle Controller Job Queue
In some versions of iDRAC (such as iDRAC10), this message may persist even when no deployment or update is actively running. This typically occurs if the Lifecycle Controller is technically "in use" by a background process or if a previous job was not properly cleared from the queue. 4. Remediation and Resolution Steps
Wait for the management chip to cycle, then reload the page and re-verify your deployment status. Method 2: Purge the Job Queue via RACADM CLI
The word “top” after a filename typically indicates one of three things: