Bonding, bridging, and VLAN configurations. Routing: Default gateways and DNS server assignments.
Avoid holding the power button down (hard shutdown) unless the system is completely unresponsive, as this can cause unclean shutdown parity checks. Step 2: Remove and Mount the USB Drive Unplug the flash drive from the server.
Unraid runs entirely from a USB flash drive. All configuration files are stored on the config folder of that drive. The two critical files for networking are: unraid reset network settings install
and plug it into a different PC or Mac. Open the flash drive and navigate to the /config folder. Locate and delete (or rename to .old ) the following files: network.cfg
Press the physical power button on your server chassis once. Bonding, bridging, and VLAN configurations
The server will ask your router for a new IP address. Bonding Disabled: Network interfaces will be separate.
Do you have to the server with a monitor and keyboard? Step 2: Remove and Mount the USB Drive
Safely eject the flash drive from your computer.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
When Unraid boots, it looks for this file. If network.cfg is missing or corrupted, the system automatically creates a brand-new file with default parameters. The default behavior is to enable DHCP on the primary network interface ( eth0 ). This architectural design makes resetting your network settings as simple as deleting or renaming the old file. Step-by-Step Guide to Reset Unraid Network Settings