V2000-c Rfid Access Control User Manual !new! -

Incorrect wiring is the #1 cause of V2000-c failure. Refer to the pinout diagram (usually on the rear of the device).

What (e.g., Maglock, electric strike) are you connecting? Are you integrating an external exit button or door sensor? Do you need assistance mapping out specific user slot IDs ? Share public link V2000-c Rfid Access Control User Manual

To adjust how long the door remains unlocked (0-99 seconds): Enter Programming Mode. Press 4 + [0-99] + # . (Default is 5 seconds). Access Mode Configuration You can choose how users authenticate: Press 3 + 0 + # Card OR PIN: Press 3 + 1 + # (Default) Card + PIN: Press 3 + 2 + # 6. Resetting to Factory Defaults Incorrect wiring is the #1 cause of V2000-c failure

A: No. The reader hardware is specific to one frequency. Check your model: V2000-c-EM (125kHz) or V2000-c-MF (13.56MHz Mifare). Are you integrating an external exit button or door sensor

To modify users, door timers, or security settings, you must enter .

Normally Open relay contact (used for fail-secure electric locks) COM (Grey): Common relay contact