V2ray Mikrotik !!better!! -

This method details how to pull a V2Ray image, configure its parameters, and run it locally on a compatible MikroTik router. Step 1: Enable Container Support

Once V2Ray is running (either inside a container at 172.16.10.2 or externally at 192.168.88.254 ), you must instruct RouterOS to intercept targeted traffic and send it to V2Ray. Step 1: Define Target Traffic via Address Lists

Consumes router CPU and RAM; requires RouterOS v7; not available on MIPSBE or MMIPS devices. Option B: Dedicated Proxy Gateway (MIPS/All Architectures) v2ray mikrotik

Having V2Ray inside a container is useless if traffic doesn't flow through it. You need to redirect traffic from your LAN clients into the container’s proxy.

MikroTik uses three tools to make this happen: This method details how to pull a V2Ray

: Check the RouterOS logs ( /log print ). This usually happens due to a syntax error in your uploaded config.json file or insufficient disk space.

: Obfuscation protocols (like VMess + TLS) are resource-intensive. If your router CPU hits 100%, consider offloading V2Ray to a separate mini-PC or switching to a lighter protocol like VLESS with XTLS. If you need help fine-tuning this setup, please tell me: What is your MikroTik router model ? Which RouterOS version (v6 or v7) are you running? This usually happens due to a syntax error

This way, only when a user requests twitter.com (resolved to your fake IP) does the traffic hit V2Ray.

For older MIPSBE or SMIPS devices, you cannot run containers. Instead, you set up V2Ray on a Raspberry Pi or a Linux VPS. The MikroTik then uses Policy Based Routing (PBR) or Mangle rules to redirect specific traffic to that V2Ray gateway. 2. Key Steps for Container Deployment (RouterOS v7)